|
|
| click on picture to enlarge |
Another shot of the cable bracket. I used a short piece of VW throttle cable housing held onto the bracket
with a 3/8 cable clamp.
|
 |
|
| click on picture to enlarge |
In this shot you can see how the bracket bolts to the Pinto cable bracket. The stock Pinto cable loops around and bolts
to the yellow bracket.
|
|
|
|
|
| click on picture to enlarge |
I mounted all the ignition components on the right rear panel. You can see the 1.35 ohm ballast resistor just above the
Duraspark control box, You definitively need this or the coil will fry.
|
|
|
|
|
|
|
| click on picture to enlarge |
This the basic Duraspark wiring diagram, The only change I made to it is the red wire going from the two wire plug
to the ingition switch now goes to the starter solenoid.
|
|
